7Ĩ Resistors Commonly used to limit current Typically 300 to 600 Ω (ohms) 8ĩ Projects Blink Sine Wave Serial Plotter Potentiometer Pot /graph Temperature sensor / LED alarm Ultrasonic distance sensor Light sensor Servo Light sensor - Servo RED - Recommended first projects 9ġ0 Demo Arduino IDE Tools Board Port Programmer: AVR ISP File / Example / 01.Basics / Blink Verify (compile), Upload Copy text of a script Pot graph File / New File / Save As - where? Tools: Serial monitor 10ġ1 Tools Tab Config Board: Arduino Nano Processor: ATmega328P CPU Frequency: 16 MHz COM Port : Programmer: AVRISP mkii Serial Monitor generally runs at 9,600 11ġ2 Arduino IDE: File / New void setup() Excerpt: sine_serial_plotter. Connect the red wire on both the servo motors with the 5V pin on the Arduino. The connections for servo motors with Arduino are as follows: Connect the black wire on both the servo motors with the GND on the Arduino. After that, connect the servo motors with the Arduino. 7 Light Emitting Diodes - LEDs An LED must be connected in series with a resistor to prevent too much current from destroying the Arduino. Connect the HOR pin on the joystick module with the A1 on the Arduino.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |